To order parts and supplies: 800.343.9353 >> eastwood.com
19
OIL RESERVOIR REASSEMBLY PROCEDURE:
1.
Set the replacement Moisture Separator into the center bore of the Oil Reservoir with the flange centered in the machined recess
(FIG 45)
.
2.
Replace the Head Plate and hold in place by loosely hand threading in 2 of the 8 Head Plate bolts to allow some movement of the Head Plate and avoid
cross-threading the line fittings.
3.
Reconnect the oil outflow line at the inlet to the Scroll.
NOTE:
Use caution not to cross-thread the compression nut on the stationary line fitting.
4.
Reconnect the oil line compression fitting at the 90° elbow attached to the Head.
NOTE:
Use caution not to cross-thread the compression nut on the
stationary line fitting.
5.
Thread in the remaining 6 Head Plate Bolts.
6.
Torque Head Plate bolts initially to 30 lb-ft [40.7Nm] then to 62 lb-ft [84.3Nm].
NOTE:
Follow Head Plate torquing sequence as shown in
(FIG 46)
.
7.
Replace Check Valve housing
(FIG 47)
.
8.
Reconnect DIN Connector to the Pressure Sensor and secure by threading on retaining ferrule
(FIG 47)
.
9.
Refill with 74 oz. [2.2 liter] of Eastwood #31718 Scroll Compressor Oil.
10.
Restore power to Compressor. Depress the “START” Button , run Compressor and check for leaks.
11.
Press the “OFF” Button and replace all panels.
FIG. 45
FIG. 46
FIG. 47
8
2
6
3
7
1
4
5
