To order parts and supplies: 800.343.9353 >> eastwood.com
17
OIL FILTER CHANGE
1.
Shut off power. Press the “OFF” Button and shut off main power.
2.
Release all pressure from the Tank and Compressor.
3.
Drain Compressor oil. Follow steps 3 through 7 of the “Oil Change
Procedure” (page 16).
4.
Loosen and remove Oil Filter from the Filter Manifold with a suitable
filter wrench
(FIG 37)
.
5.
Install replacement Oil Filter
(FIG 37)
.
6.
Add 74 oz. [2.2 liter] of Eastwood #31718 Scroll Compressor Oil to the fill
port of the Oil Reservoir using a suitable funnel (not included).
7.
After the recommended amount of Oil is added, view the Sight Gauge on
the side of the Oil Reservoir to make sure that it reads FULL (At or above
the “M” Line but not above the “H” Line
(FIG 35)
. If the oil level is below
the “M” Line, oil must be added.
8.
Replace Oil Fill Plug and tighten securely.
9.
Restore power to Compressor. Depress the
“START”
Button ,
run Compressor and check for leaks.
10.
Press the
“OFF”
Button and replace all panels.
AIR FILTER CHANGE
1.
Grasp the sides of the plastic Air Filter Housing located at the top of the
Scroll Air Intake Manifold and rotate 1/8 turn Counter Clockwise (as viewed
form filter housing)
(FIG 38)
.
2.
Remove Air Filter Housing.
3.
Remove the Paper Element and discard it
(FIG 39)
.
4.
Replace the Paper Element with a new one and replace the Air Filter
Housing by rotating 1/8 turn Clockwise until it latches and molded in
arrows are aligned
(FIG 40)
.
Used Oil is a polluting material and should be disposed of in
compliance with local regulations.
FIG. 37
FIG. 38
FIG. 39
FIG. 40
Off
Rotate
Latched
✓
✓
PERFORM THE FOLLOWING STEPS BEFORE PERFORMING
ANY MAINTENANCE PROCEDURES!
•
Shut off power. Press the “OFF” Button [B] (Fig 9)
and shut off the main 3 phase power switch to the unit.
•
Release all pressure from the Tank and Compressor.
