To order parts and supplies: 800.343.9353 >> eastwood.com
5
ASSEMBLY
• Locate the Lower Die
[A]
to the Base
Plate
[B]
with two M8 x 20 mm screws
and washers
(FIG 1)
. Tighten with a
6mm hex key.
• Insert threaded ends of Slide Posts
[C]
into holes in Base Plate
[A]
and secure
with two M10 Nuts and Washers
(FIG 1)
. Tighten with a 16mm wrench.
• Place two Release Springs
[D]
over
Slide Posts
[C]
(FIG 2)
.
• Slide sleeves of the Upper Die
[E]
over
the Slide Posts
[C]
(FIG 3)
.
• Thread four (4) M8 Set Screws into
the cup feature of the Upper Die
[E]
.
SET-UP
The Eastwood 12” Press Brake Attachment is
designed as an accessory for use in a 12 to 20
ton hydraulic press.
• Center Press Brake over the crossbar of
hydraulic press (not included).
• Slowly draw down the ram of the
hydraulic press so that it nests within
the cup on the top of the Upper Die
[E]
.
Secure to ram by tightening the four
Set Screws with a 6mm hex key.
Use only in a Shop Press of
20 Tons or less.
FIG. 1
FIG. 2
FIG. 3
✓
A
B
C
✓
✓
✓
✓
B
✓
A
✓
✓
D
D
✓
C
✓
C
✓
A
✓
E
✓
B
✓
✓
✓
✓
Set Screw (4)
