6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
OPERATION
• Follow specific operating instructions supplied with the particular hydraulic press to be used.
• Measure and mark the desired bend line on the workpiece panel.
• Slide metal panel between the Dies lining up your pre-marked bend line with the sharp, beveled
edge of the Male Die.
• Center metal panel in Press Brake.
• Gently and slowly draw down the hydraulic ram of the hydraulic press to begin creating the
desired bend.
NOTE:
The use of an angle gauge or protractor (not included) is recommended.
• Depending on the particular alloy being bent, it may be necessary to push the dies slightly
beyond the desired finished angle to allow for “springback”. Some trial and error is suggested
with scrap material before making final bends.
MAINTENANCE
• Keep all areas of the tool clean particularly those surfaces that contact sheetmetal workpieces.
Dirt and metal chips can cause uneven clamping and inaccurate bends.
• Store in a clean & dry environment when not in use. Coat all machined surfaces with a light
lubricant film of oil or suitable protectant to prevent rust formation.
