33
Eastman
Over a Century of Cutting Expertise
®
Form E-564
When a fault occurs, the drive fault relay is opened, the output stage is switched off (motor loses all torque), or
the load is dynamically braked. The specific drive behavior depends on the type of fault. The LED display on the
front panel of the drive shows the number of the fault that occurred. If a warning is issued prior to the fault, the
warning is shown on the LED and has the same number as the associated fault. Warnings do not trip the power
stage of the drive or fault relay output.
Amplifier Error Codes
Fault
Message/Warning
Cause
Remedy
--
--
24V Control Power input voltage
dip. or Auxilary encoder 5V (X9-9)
shorted
Insure adequate 24V supply cur-
rent capacity for the system. or
check and fix X9 wiring.
E0082
SD card is not inserted.
No SD card inserted or SD card
inserted with wrong orientation.
Insert SD card with correct
orientation.
E0083
SD card is write protected.
SD card protection clip in wrong
position.
Remove with protection from SD
card.
E0084
SD card hardware not in
-
stalled.
No I/O option boad installed or SD
card device is faulty.
--
E0095
File not found on SD card.
SD card damaged or file name
has been changed manually or
deleted.
--
E0096
File error trying to access the
SD card.
File on SD card can't be read.
--
E0097
File system error accessing
the SD card.
File system on SD card can't be
read.
Use supported SD cards only.
E0098
A parameter count not be set
in the drive.
--
--
E0099
There was an error writing to a
file on the SD card.
--
--
E0100
SD card read/write in prog
-
ress.
--
Wait until read/write process is
done.
F0
--
Reserved.
--