OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Page 5 of 19
Place two long square bolts (13)
through holes on the leg and burner
body (figure 3). Place burner grate (4)
onto the two bolts (figure 4) making
sure that the vertical posts are on the
outside of the burner body.
Fig. 3
Fig. 4
Secure burner grate and leg to the
burner body using a flat washer (10),
lock washer (11), and nut (12) (figure
5). Tighten with provided wrench
(figure 6).
Fig. 5
Fig. 6
Place a short square bolt (9) through hole on the bottom of leg support (figure 7). Secure using a flat washer
(10), lock washer (11), and nut (12) (figure 8). Tighten with provided wrench. Repeat above steps to attach
remaining two legs and burner grates (figure 9).
Fig. 7
Fig. 8
Fig. 9
Step 1.2 Regulator Hose Assembly
One adjustable wrench is needed when attaching the hose to the appliance.
Place the shutter spring (#8) onto burner
orifice/regulator hose assembly (#5) by sliding the
small end of the shutter spring onto the burner
orifice/regulator hose assembly (figure 10).
Fig. 10
Set the air shutter (#7) onto the burner element (#3)
by placing it on the casting (figure 11).
Fig. 11
IMPORTANT: Line up hose/orifice assembly (#5) with the hole in the burner element (#3) so the orifice is
perpendicular to the burner element (figure 12).
Finger-tighten orifice into the hole and then wrench tighten
with an adjustable wrench 1 to 2 revolutions or until snug (figure 13).
DO NOT OVER TIGHTEN. The
connection is tight enough when one cannot loosen the hose/orifice by hand. Proper connection is
critical for correct operation of the burner.
•
Do not
disassemble the regulator hose assembly or regulator. This is
a pre-assembled unit.
•
The high pressure regulator hose assembly supplied must be used.
Replacement high pressure regulators assemblies must be those
specified by Eastman Outdoors.
