Assembly and Operation Instructions
F80_RevNov_21
PAGE 5
TO COMPLETE ASSEMBLY
Install AGITATOR, bend the AGITATOR up slightly to prevent contact with the STANDARD-OUTPUT tray, and install debris screen.
Press over 1/4 turn fasteners to secure
This only applies to the RED 3-hole drop STANDARD-OUTPUT Trays.
The HIGH-OUTPUT (Blue) and LOW-OUTPUT (Black) Trays do not use the AGITATOR or DEBRIS SCREEN shown below.
TRAY INSTALLATION
Step 1:
Ensure the hopper is clean and there is no debris trapped
around the tray mounting area.
Step 2:
Install the PIVOT ROD CLIP
into the Shut-off of the selected
TRAY
.
Step 3:
Insert the PIVOT ROD
into the CLIP
.
TIP:
The CLIP
may have a
burr in the hole, use a Phillips screwdriver to remove the burr. See
to make
installing the PIVOT ROD
easier. Pliers may be required to help squeeze the
PIVOT ROD
into the CLIP
.
Step 4:
When the ROD
is secure inside the CLIP
push the free end of the
CLIP
over the PIVOT ROD
to firmly secure the rod to the clip.
Step 5:
I
nstall the TRAY
from the top downwards into the hopper (see
figure
) positioning the center hole of the tray over the PINION SHAFT from the
gear box with the PIVOT ROD through the bottom of the hopper and facing
toward the spreader’s handlebar. For ease of locating into position the shut-off of
the chosen tray is best in the open position, with the exception of the red
STANDARD-OUTPUT
TRAY where the two adjustable throwing ports are best in
the closed position.
NOTE:
The gearbox can be moved along the axle to ease aligning of the tray hole
and the PINION SHAFT.
