Assembly and Operation Instructions
F80_RevNov_21
PAGE 7
STANDARD-OUTPUT TRAY
:
Make sure the drop holes in the
bottom of the hopper are
FULLY OPEN
when the RATE
CONTROL HANDLE is on #30. If
the shut-off is not set correctly,
please adjust CONTROL ROD at
the PIVOT to position the shut-
off for
FULLY OPEN
hopper
position at #30 on the RATE
CONTROL LEVER. Install the
horizontal AGITATOR through
the PINION SHAFT in the
hopper bottom. Finally, install
the DEBRIS SCREEN onto the
Quarter-turn fasteners and
push down to snap and secure
.
Review the CONTROL LEVER
position to confirm that it is
set so that the rear edge of
the LEVER is resting at #30
(the stop) and the drop
holes are open. If the shut-
off is not properly
positioned, you will need to
adjust the CONTROL ROD at
the PIVOT BRACKET shown
below.
TIP
:
If your shut-off is not able to
OPEN
fully, loosten the bottom nut a few turns, then tighten the upper nut so
that it allows you to push the
shut-off fully open
. Next, tighten each nut so that they contact the PIVOT BRACKET
without moving it.
Then, if the CONTROL LEVER does not stay in position causing the setting rate to
change without your intervention, you can adjust the drag on the LEVER by tightening
or loosening the nut shown to the right until the drag is appropriate.
OPERATING INSTRUCTIONS
Obtain proper setting for material to be used from the enclosed SETTING MATRIX included with this spreader, or
from our web site under the MANUALS SECTION.
Set stop bolt on rate gauge assembly to the proper rate setting.
