Assembly and Operation Instructions
EarthWay 14050
–
50
’ Hose Reel
PAGE 3
Mounting Steps
1.
Using stud-finder, locate stud and mark the location.
2.
Tape the drilling template on the wall at a convenient height, making sure the holes are centered on the stud.
3.
Check the hole centers with the level to ensure they are plumb.
4.
Drill (4) four holes with a Φ
3mm (Φ
1/8in) masonry drill bit on the template centers.
5.
Fasten the mounting bracket with four lag bolts and washer to the wall or timber post.
6.
Hang the hose reel on the wall bracket and secure it by inserting the mount tube.
7.
Connect with inlet hose end with the water source.
MOUNT TO HOLLOW WALL AND MASONRY WALL
Recommended tools:
• masking tape
• bubble level
•
power drill
• Ø
10mm (Ø 3/8 in) drill bit
• hammer or mallet
•
10mm socket, wrench or adjustable wrench
Steps
1.
Tape the drilling template on the wall at a convenient height, making sure the
holes are between studs.
2.
Check the hole centers with the level to ensure they are plumb.
3.
Drill (4) four holes with a 10mm (3/8in) masonry drill bit on the template centers.
4.
Tap plastic anchors (B.3) into holes with a hammer or mallet.
5.
Fasten the mounting bracket with four lag bolts and washer to the wall or
timber post and ensure drive mounting screws into the plastic anchors) in
the
wall.
6.
Hang the hose reel on the wall bracket and secure it by inserting the
mount tube.
7.
Connect with inlet hose end with the water source.
