Assembly and Operation Instructions
EarthWay 14050
–
50
’ Hose Reel
PAGE 4
OPERATING INSTRUCTIONS
1.
Pull the hose out to the desired length. The hose will automatically lock in position.
2.
To unlock and retract, give the hose a short pull. Walk the hose back to the hose reel. If
you pull the hose longer than 12 inches you may re-lock the hose.
3.
To avoid injury and damage, always hold the hose while it is retracting.
4.
If the hose becomes tangled and will not retract - slowly pull out the hose
past the tangled section and then allow the hose to slowly retract while
guiding the hose back into the hose reel. Always ensure the hose is
clean and not twisted.
ADJUSTING THE STOP-BALL
The stop-ball location can be adjusted to ensure the hose is always within reach.
Recommended tools
:
No tool is needed.
Steps
1.
Pull out the hoes to the desired length, ensuring the hose reel is locked (will not rewind).
2.
Open the latch on the stop ball and move it to the desired location.
3.
Re-latch the ball.
CAUTION:
ALWAYS MAKE SURE THE HOSE REEL IS LOCKED BEFORE REMOVING THE STOP-BALL, AND
MAKE SURE THE STOP BALL IS SECURELY FASTENED BEFORE UNLOCKING THE REEL.
▪
WARNING:
ALWAYS HOLD THE HOSE REEL UNTIL IT COMPLETELY RETRACTS INTO THE HOSE REEL.
▪
WARNING:
THE YELLOW TAPE MARKS ON THE END OF HOSE LENGTH.
▪
RELEASE WATER PRESSURE WHEN NOT IN USE.
▪
CAUTION:
DO NOT RELEASE THE HOSE ALLOWING TO REWIND ON ITS OWN.
