Specifications are subject to change without notice 9
Test the alternator output. Factory alternators will produce 60 to 80 amperes at best. Wear and
heat will reduce the output by 40%.
Alternator ground (-) must be reinforced, use 4-gauge cable instead of the factory 8-gauge.
Alternator positive (+) to battery (+) must be reinforced. Use 4-gauge cables.
Check your battery condition. Batteries degrade after a while.
Battery (+) to amplifier (+) , must be a 4-gauge cable.
Ground amplifier to chassis using 4-gauge cable, keep the cable short (maximum 2-feet).
Use 1 farad capacitor to compensate for surges in demand.
We recommend the use of 1 to 2 auxiliary batteries depending on 1, 2, or 4-Ohm loads.
WARNING:
Make sure that the amplifier is completely off and not connected to any power
source during the wiring process. Failure to do so may result in a short that will damage the
amplifier or cause bodily harm or injuries.
Take note of the following prior to installation:
1. You must confirm that your power supply can deliver spontaneous power to the amplifier when
needed to propel the load.
2. Bulletproof ground:The ground cable must be 4-gauge minimum and also very short and well
attached to the chassis.
Ω
4
FUSE
One Single 2-Ohm Subwoofer (1-Ohm Minimum)
WIRING CONFIGURATIONS
WIRING PREPARATIONS
