4 Specifications are subject to change without notice
1. RCA INPUT & OUTPUT:
Low level input and output with range of 0.2V to 5V RMS.
Be sure to use a high low level adapter if your vehicle does not have a subwoofer
output.
2. Crossover:
The high pass filter (HPF) is used to filter out unwanted low frequen-
cies from 15Hz–80Hz and the low pass filter (LPF) is used to filter out unwanted
mid and high frequencies from 80Hz–20kHz.
3. GAIN CONTROL:
The gain control is used to regulate the amplifier’s sensitivity to
match the signal output voltage of the audio source/head unit. Note that this is not a
volume control. Always start at the MIN position and slowly increase the gain. Stop
as soon as distortion is heard and then lower the gain until distortion disappears
and only clear sound is produced.
4. BASS BOOST:
Boosts the chosen center frequency from 0 to +12dB.
5. FREQUENCY ADJUST:
Used to adjust the boosted center frequency.
6. REMOTE SUB LEVEL:
This is used to adjust the amplifier’s bass output from a loca-
tion of your choice. A typical location for the remote install is somewhere on the
dash of your vehicle that makes it easily accessible.
7. LED INDICATORS:
There are three LED indicator lights that show the working sta-
tus of the amplifier. Blue indicates that the amp is powered on and functioning prop-
erly. Orange indicates that the input signal of the amp is overpowered. Refer to the
gain settings. Red indicates that the amp is on protection mode due to improper in-
stallation or internal damage done to the amp.
8. SPEAKER WIRE OUTPUTS:
These amplifiers feature set screw-down style speaker
wire output connectors.
9. +12V BATTERY TERMINAL:
This screw-down style terminal is used to connect the
amplifier to the vehicle’s battery positive (+) using the specified wire gauge size
shown underneath the terminal block.
10. REMOTE TERMINAL:
This screw-down style terminal is used to connect a remote
cable from the amplifier to the remote terminal of the head unit.
11. GROUND TERMINALS:
This screw-down style terminal is used to connect the
amplifier to the vehicle’s chassis/ground using a short 4-gauge wire (2 feet maxi-
mum in length).
END OF PLATE OVERVIEW
