EarthQuake MINIME P10V2, User Manual

Page: 8 / 21

Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
Control Panel Overview continued
subwoofer is running in full range mode (20Hz
(8) IR Input
- 2kHz) and the frequency adjustment is
Simply plug the remote eye provided in the IR
disabled. When the switch is in SUB position,
INPUT. Once plugged in, place the remote eye
the subwoofer reverts to manual frequency
anywhere in the room where it is convenient for
adjustment, allowing the user to operate and
the user to control the amplifier using the
fine tune the subwoofer to his/her preference.
included remote control.
(12) 0-180° Phase Adjustment
(9) AUTO/ON/OFF Switch
This is a 3-way switch. When ON, the amplifier
will remain on regardless of signal presence.
When set to AUTO, the amplifier will only turn
on when audio signal is detected. Additionally,
(13) AC Power with Built-in Fuse
the amplifier will go to sleep/stand-by if it does
This AC line connector is fused to protect the
not detect any signal after 15 minutes. When
subwoofer from unwanted power surges. Be
set to OFF, the amplifier will remain off
sure to use the proper fuse rating when
regardless of signal presence. Note that the
replacing the fuse:
MAIN POWER switch must be ON for this
110-120V~60Hz: ø5x20mm, T6.3AL/250V
feature to work.
220-240V~50Hz: ø5x20mm, T3.15AL/250V
(10)40Hz - 160Hz Frequency
Adjustment
(11) LFE/SUB Operation Switch
When the switch is in LFE position, the
This 0° - 180° switch allows user to
synchronize the subwoofer to obtain better
and more precise bass response.
This knob allows user to set the subwoofer’s
cut off frequency. Signals above the set
crossover frequency will be gradually rolled off
to prevent them from interfering with the
surround speakers.
To access the fuse compartment, simply
unplug the subwoofer from any power source,
place a flat-head screw driver in the small
notch and pry it open as illustrated.
8 MiniMe Manual P10
V2
/P12
V2
(12)
(11)
(13)
(8)
(9)
(10)