High Level Setup - Single Sub
The MiniMe
has a high/speaker level
input connection. This setup is a solution when you
experience excessive noise or hum with the line level
input.
Simply connect the speaker wire (up to 16-gauge)
from the receiver’s SPEAKER OUTPUTS to the
MiniMe P10
V2
/P12
V2
Remember to always connect red-to-red and black-
to-black when making conections between a
receiver/processor to the subwoofer. You will notice a
lack of bass from your subwoofer if you inadvertently
reverse one of the connections (i.e. red-to-black).
In case the MiniMe P10
V2
/P12
V2
becomes out of
phase with the main front speakers, adjust the phase
shift to correct the problem. Note that maximum bass
is only achieved when the sub is in phase with the
speakers in your system.
P10
V2
/P12
V2
’s SPEAKER .
Connecting Your Subwoofer(s) cont’d
Specifications are subject to change without notice.
back of typical
processor/receiver
SPEAKER OUTPUT
CENTER
FRONT
L
-
L
R
L
R
R
SURROUND
SUR. BACK
+
-
+
NOTE:
DO NOT USE HIGH LEVEL AND LOW
LEVEL INPUTS AT THE SAME TIME
MiniMe
Manual 11
P10
V2
/P12
V2
Summary of Contents for MINIME P10V2
Page 20: ......