HCM-IMM (10/16) 10
Installation
– Electrical & Start-Up
1.
After turning “OFF” power to all EarthLinked
®
and field supplied system components at
the appropriate breakers
remove the Hybrid Cooling Module control box access
panel.
2. Connect the appropriate sized line voltage wires and ground wire to the Hybrid Cooling
Module, as shown in Figure 5. Seal-tight line voltage entrance is located on the back
side of the HCM, see Figure 6.
WARNING!
BEFORE REMOVING ANY ACCESS PANELS AND INITIATING ANY PHASE
OF
THIS INSTALLATION, MAKE SURE THAT POWER IS TURNED “OFF” TO
ALL EARTHLINKED
®
AND FIELD SUPPLIED SYSTEM COMPONENTS.
FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE, SERIOUS
INJURY OR DEATH.
WARNING!
WEAT ADEQUATE PROTECTIVE CLOTHING AND PRACTICE ALL
APPLICABLE SAFETY PRECAUTIONS WHILE INSTALLING THIS
EQUIPMENT. FAILURE TO DO SO MAY RESULT IN EQUIPMENT AND/OR
PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
WARNING!
The Hybrid Cooling Module cabinet must have an unbroken ground.
The ground must be installed in accordance with applicable electrical
codes. Failure to follow this warning can result in injury, fire or death.
