Earlex WS125US, Manual

Page: 2 / 12

GrOUNDiNG iNStrUCtiONS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing
an escape wire for the electric current. This product is equipped with a cord having grounding wire with an appropriate grounding
plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
DaNGer! - Improper installation of the grounding plug can result in a risk of electric shock.
If repair or replacement of the cord or plug is necessary, have your nearest Earlex Authorized Service Center replace it.
Check with a qualified electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to
whether the product is properly grounded. Do not modify the plug provided; if it will not fit the outlet, have the proper outlet installed
by a qualified electrician.
eXteNSiON COrDS
Use only a 3-wire extension cord that has a 3-blade grounding plug, and a 3-slot receptacle that will accept the plug on the product.
Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. For lengths less than 50', 16 AWG extension cords should be used, and over 50' use 14 AWG
extension cords. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating.
prOteCt YOUr HOme!
The heat generated by the boiler unit can mark carpets, soft furnishings, table tops, cabinets, etc.
To prevent this we recommend placing the unit on a wooden board, tray or other barrier - making sure it will not slip off one side or tilt
during use.
Dust sheets or newspapers are not suitable heat protectors for delicate surfaces.
CaUtiON !
Check the state of your plaster before starting work.
Steam can loosen weak, porous or poorly bonded plaster - which also loosens readily if cracked, holed or if the steamplate is held in
one position for too long after the paper is soaked.
Weak plaster can normally be detected by tapping a few areas of wall. A hollow sound indicates that you should proceed only with
extreme care - stopping immediately if you hear a cracking sound or plaster starts to break loose.
The steam stripper is safe for drywall/plaster board surfaces but whatever the material, it is always wise to check a small area before
starting work.
• Stay clear of steam, hose, hose fittings and steam
plate surface. DO NOt place hand in front of steam
plate.
• ensure boiler is placed on a flat level surface, and
should the boiler become tilted in use - level again
immediately. Failure to do so can result in severe
overheating, complete element failure and void your
guarantee.
• Water drops are hot and may burn skin. Use extreme
caution when using steamplate overhead, and
routinely empty water from steamplate. Wear eye
protection.
• allow parts to cool before changing accessories
and/or opening filler cap.
• NeVer point steamplate at anyone.
• DO NOt over fill water container.•
• DO NOt strain or kink hose. replace hose if it is
cracked, worn, or damaged. Never repair a damaged
hose.
• DO NOt allow water to boil dry. Boiling dry may
cause overheating and fire.
• power cord must be connected to grounded
(3 prong) outlet.
• replace a worn or damaged power cord. Never
repair a power cord.
• DO NOt pull water container by power cord.
• DO NOt allow water or steam to enter light switches
or sockets.
• DO NOt stand or sit on water container.
• DO NOt modify parts or components. Never repair
damaged or worn parts. always replace with new,
identical parts.
• Water container must rest on a sturdy, level surface
and in an upright position.
• Keep steamer away from children.
• DO NOt leave steamer unattended.
• Never change tools when the unit is operating.
• Use only standard faucet water. Never add
detergents or chemicals.
SaFetY rUleS
US
2