11
Spray Gun Design Registration
GB 3006933
Copyright & Design Right Reserved © 2012
GUARANTEE
This product is guaranteed for a period of 12 months for ordinary use and 6 months for hire purposes or where
the unit is lent to other users.The guarantee is against faulty manufacture and materials. Whilst every possible
care is taken by Earlex to ensure that our products leave the factory in good working order, Earlex cannot
under any circumstances accept liability for problems or damage caused by their subsequent use. It is the
responsibility of the user to ensure that surfaces to be treated or cleaned are suitable for spraying. This
guarantee does not affect your statutory rights.
EC Declaration of Conformity
We declare that the unit HV7000 conforms to: LVD 2006/95/EC, EN60335-1, EMF EN 50366,
EN 62233; EMC 2004/108/EC, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3.
Tim Hopper Technical Director
INFORMATION ON THE DISPOSAL OF WASTE ELECTRICAL AND ELECTRONIC
EQUIPMENT KNOWN AS WEEE
Your attention is brought to new directives applicable to the disposal of this electrical equipment,
where in accordance with the legislation this product must not be disposed of in your normal
household waste. Instead it is your responsibility to dispose of this type of waste by handing it over
to special designated collection points for recovery and recycling. This product is marked with a
‘Wheelie bin’ symbol with a cross on it to remind you of this action. The objective of this directive is
to help conserve resources and ensure that it is recycled in a manner that protects human health
and the environment. For more information about where you can drop off your waste please contact
your local authority, take back facilities are free of charge.
EARLEX LTD WILL ACCEPT NO RESPONSIBILITY FOR THE USE OF THIS PRODUCT IF
USED FOR ANY PURPOSES OTHER THAN THOSE DETAILED HEREIN
MAINS CONNECTION
Your unit has been supplied with a mains cord and a fitted plug. This is identified by the fuse holder
in the base of the plug. Please read the following safety instructions before use.
1.
If the fitted plug is cut off from the mains cord then the plug must be disposed of safely. NEVER
under any circumstances insert such a plug into a 13 Amp socket-outlet.
2
.
NEVER
under any circumstances use the appliance or mains cord without the fuse cover fitted.
This is the little cover fixed into the base of plug to hold the fuse in place.
3
. If you lose the fuse cover then please contact any electrical dealer for a replacement or ring our
helpline above.
4
. A replacement fuse must be rated at 13 Amps. This must be manufactured and approved to
BS1362.
5
.
IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED ELECTRICIAN.
If you need to fit a plug to the mains cord, this should be fitted in accordance with the wiring
instructions below, and will need to be fitted with a 13 Amp fuse. If in doubt consult a qualified
electrician.
WARNING! THlS APPLIANCE MUST BE EARTHED.
If you are using an extension lead it must be
rated at a minimum of 10 Amps and fully unwound. Do not operate with a cord rated less than 10
Amps as this will cause premature failure of the element which is not covered by the guarantee. As
the colours of the wires in the mains cord of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connected to
the terminal in the plug which is marked with the letter E or by the
earth symbol, or coloured green.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
