Eagle KEE E15, Operator'S Manual

Page: 13 / 108

E15h SPRAYER- Console Overview
Below will show all the functions that can be displayed in each window. Most of the
functions will have to be enabled in the “Sprayer Setup” before the functions can
be displayed in the windows. The first function listed is the default function
displayed on the screen. See Operation of Sprayer (Section 7.0) on how to access
these functions.
Sub Area Window-
1.
Sub Area
- Displays area covered for the active sub area.
2. Sub Area Number-
Displays the active Sub Area number.
3. Total Area-
Displays the total area accumulated by the sprayer since the last reset.
Coverage Rate-
1. Coverage Rate-
Displays the working rate of the sprayer in units/ha.
2. Row Width-
Displays the current preset ‘Row Width’ of the sprayer. 4 preset Row
Widths can be set. The current ‘Row Width’ displayed is indicated by the number
(1,2,3 or 4) in the bracket.
3. Pressure1-
Displays the ‘live’ pressure reading from the electronic pressure sensor.
4. Fan 1 Speed-
Displays the actual fan speed (in RPM) of the shaft speed the sensor
is fitted to, marked ‘Fan 1 Speed’ on the loom. Is only displayed when 1 or 2 Fan
Monitors are selected in Section .
Volume Left Window-
1. Volume Left-
Displays the amount of product left in the tank.
2. Flush-
Displays the status of the Flush function whether OFF or ON; if ON
displays the countdown in seconds of the time left for the flush function to finish
flushing out the boomspray. See Section 3.12.2 to enable Flush function if fitted.
Flow Rate Window-
1. Flow Rate-
Displays the ‘live’ Flow rate in volume/minute.
2. Pump Speed-
Displays the actual speed (in RPM) of any shaft the sensor is fitted
to. Example would be a PTO input shaft. See Section 3.20 to enable, if fitted.
3. Aux Shaft Speed-
Displays the actual speed (in RPM) of any shaft the sensor is
fitted to. See Section 5.11 to enable, if fitted.
4. Fan 2 Speed-
Displays the actual fan speed (in RPM) of the shaft speed the sensor
is fitted to, marked ‘Fan 1 Speed’ on the loom. Is only displayed when 2 Fan
Monitors are selected in Section .
Volume Used Window-
1. Volume Used-
Displays the amount of product applied, since the last reset.
2. Auxiliary-
Displays the status of the Auxiliary switch, whether OFF or ON. Enable
this function for example, if Working Lights are fitted to the sprayer loom. See
Section 3.12.2 to enable, if fitted.
3. Dump Override-
Displays the status of the Dump Override, whether ON or OFF.
The Dump Override allows a ‘Chemical Induction’ pump to be fitted to the sprayer.
All Section and Master switches have to be switched OFF to enable ,Dump Override’.
See Section 3.22 to enable.
4. Data Logger Status-
Displays the current ‘JOB NUM:’ (Job Number) and ‘SET
RATE:’ if the ‘Data Logger’ is ENABLED. See Section 3.14 to enable, if fitted.
13
V 1.0 11/05