Eagle 2000F Series, Operation Manual

Page: 22 / 49

- 22 -
5.1 Troubleshooting Guide
Error Code Possible Cause Solution
Machine will not function

Machine not plugged in.

Outlet where Machine is plugged
into has no power or bad outlet.

Power cord has been damaged.

Machine internal circuit breaker
tripped.

Plug machine into 110VAC
outlet.

Check to see if outlet has power.

Call service for new cord.

If machine breaker is tripped call
tech support.
Machine has power and
will not function
"Machine Pause"

Input signal 05 is lit on PLC.

E-stop is pushed on main panel.

Carriage base safety switch pushed.

Film Feed Door is not closed
properly.

Drive display should display "rdy"
for them to be ready.

Check all E-stop and debris
under carriage.

Adjustment may be needed to
carriage safety switch reference
4.2 carriage maintenance .

Close door with a firm push Do
Not slam or force.

If drive don't display "rdy" call
tech support
Machine will not stop at
home

Input signal 03 is not lit on PLC.

Bad connection between mass and
turn table.

Bad Limit Switch/ Adjustment

This Input will only illuminate
when the Limit Switch is on the
cam location.

Tighten or replace connector
ensure that their no pinched
wires.

Replace Limit Switch or adjust so
that rides on cam properly.
Machine will not start job
after reset

Input 04 is not lit

Photoelectric Eye is not reading
package.

Photoelectric Eye is not sending
a signal to PLC.

Ensure that the both green and
amber are illuminated with load
in place.

Call tech support
Screen displays Chinese
lettering

DB9 connector has come
unplugged or is loose.

DB9 connector is bad

Tighten connector on PLC and
Screen / Be sure to check power
connections as well

Replace DB9 Connector / call
tech support