NOTE: Legs and undershelf must be
assembled BEFORE securing legs to table.
Figure 1
Optional Bolted Undershelf (for DHT Series only)
2
Note:
OB/CB cabinet series do not require undershelf and leg assembly.
Standard Cutting Board (for all models)
1. Attach shelf support brackets to support shelf, using acorn nuts, washers, bolts and
predrilled holes. Note: acorn nuts must be at the top.
2. Install machine screws into threaded fasteners on hot food table. Do not tighten.
3. Align keyholes in mounting brackets with screws and mount support shelf/bracket
assembly to table. Tighten screws.
4. Align holes in cutting board with acorn nuts, and place cutting board onto
support shelf.
Optional Hardwood Cutting Board
with Drop Brackets (for all models)
Optional Plate Shelf
1. Hook metal plate shelf into bottom flange of plate shelf brackets.
2. Using keyholes on support shelf brackets, mount plate shelf/bracket assembly onto
support shelf/bracket assembly.
ASSEMBLY INSTRUCTIONS
1. Place table on top with gussets facing up.
Caution
: Use cardboard or other material to prevent scratching top.
2. Install legs into gussets. Make sure rivet in leg is closer to gusset than to
the foot end.
3. Align undershelf gussets with legs, and slide undershelf down legs to
desired position. Do not force or beat corners as damage could occur.
4. Tighten set screws* in undershelf gussets to secure undershelf
(see
Figure 1
) and install feet into legs, using a rubber mallet.
5. Tighten set screws* in gussets to secure legs to table.
6. Place table on back with control knobs up.
7. See applicable cutting board mounting instructions below.
NOTE: Legs and undershelf must be
assembled BEFORE securing legs to table.
Figure 1
Standard Adjustable Undershelf (for DHT Series only)
1. Place hot table on top with gussets facing up.
Caution
: Use cardboard or other material to prevent scratching top.
2. Install legs into gussets.
3. Mount undershelf to legs by inserting bolt thru hole in leg and thru hole in
corner of undershelf and tighten with hex nut (see
Figure 1
).
4. Tighten set screws* in gussets to secure legs.
5. Place hot food table on back with control knobs up.
6. See applicable cutting board mounting instructions below.
support shelf
bracket
plate shelf
bracket
washer
hex bolt
acorn nut
stainless steel support shelf
optional plate shelf
cutting board
drop
bracket
cutting board assembly
1. Mount drop brackets to table, using machine screws
and threaded fasteners on table.
2. Mount cutting board assembly to drop brackets on
table.
3. Raise cutting board up until it is in horizontal
position and slide toward hot table.
cutting board
assembly
drop bracket
machine screws
to screw into unit
channel (inside
cutting board
assembly)
* To meet NSF standards:
Set screws must be filled with NSF-approved sealant.
set screw
*
