Eagle Access Control Systems X9L, Installation & Owner'S Manual

Page: 26 / 34

24
X9 Swing Rev - H
SINGLE Gate Progr
amming
PROG
Pres
s
M1
Pres
s
P/P
Pres
s
P/P
M1
Program Travel Distance and Pause Time to Close Gate(s)
SINGLE Gate Programming
1
ON
2 3 4 5 6 7
PROG
P3 P/P
TR1
LD1
BSC BSA FT1 FT2 J1 J2 STP
1
2
3
4
5
6
7
8
Rall.
9
O
N
2 M.
11
O
N
Almost full
open position
Start Pause
Hold down the PROG button for at least 3 seconds until led LD1 lights up.
“Programming mode” has been activated.
Press the P/P button. The gate should begin to CLOSE , if it opens instead, shut-off the power ,
reverse motor M1 Red and Black wires and start again.
When gate has closed it will stop and start opening automatically .
When the gate has opened completely (reaching the mechanical stop),
PAUSE TIME memorization will start automatically .
NOTE: If automatic reclosing pause is not desired you may
press P/P button immediately .
Once the desired PAUSE TIME has elapsed, Press P/P button .
Gate will begin to close .
Shut-off the power. Manually release the operator and move to an
almost fully open position. Re-lock operator and turn power back ON .
LD1
M1
M1
M1
M1
6
9 3
12
Stop Pause
End Program
6
9 3
12
M1
LD1
Turns OFF
Limit switches and mechanical stops MUST be CORRECTLY positioned
BEFORE programming either SINGLE or BI-PARTING gates on next page.
NOTE: If the operator stops
before reaching the travel
limit,
decrease the TR1
reversing sensitivity
adjustment (clockwise).
Closed
DIP-Switch 9 set to ON only AFTER programming complete. The OPTIONAL programmed slow down times will be enabled .
BEFORE beginning programming, check the correct DIP-Switch settings and connections by observing the leds:
OPTIONAL
Slow Down
programming: Not required to complete programming. Typically used with uneven opening, longer or heavier gates.
PROGRAMMING & ADJUSTMENTS
DIP-Switch 11-2 M OFF for SINGLE Gate.
DIP-Switch 11-2 M ON for Bi-Parting Gates.
DIP-Switch 9-Rall. ON DURING programming: Self-learning cycle that
slows down after 5 SEC so it can find the mechanical travel limit safely .
Use this setting for longer and/or heavier gate.
DIP-Switch 9-Rall. OFF DURING programming: Rapid mechanical
travel limit detection without slow down.
BSC C PED STP P/P C
12 13 11 10 9 8 7 6 5 4 3 2 1
SC ST
BSC C J1 J2 PC PA PED STP P/P C
12 13 11 10 9 8 7 6 5 4 3 2 1
SC J1 J2 ST
BSC, BSA, FT1, FT2, J1, J2 and STP MUST be LIT
BSC, BSA, FT1, FT2, J1, J2, PC, PA and STP MUST be LIT
SINGLE Gate
Bi-Parting Gates
When the gate has closed completely , the motor will stop, led LD1 will turn OFF and programming
mode ends.
Pulling the 4 Amp fuse
will shut-off power.
ON / OFF