27
X9 Slide Rev - H
P
o
wer F
ail Oper
ation
Adjust Rev
erse Sensor
1
ON
2 3 4 5 6 7
PROG
P3
P/P
TR1
LD1
BSC
BSA
FT1
FT2
J1
J2
STP
IMPORTANT:
The level of sensitivity has to do with the weight of the
gate and the condition of the installation. A heavier gate will require
LESS
sensitivity and a lighter gate will require
MORE
sensitivity.
Proper function of reverse sensor:
When meeting an obstruction in the
CLOSING
direction, the gate will
STOP
, reverse direction and return to the
FULL OPEN
position.
When meeting an obstruction in the
OPENING
direction, the gate will
STOP
and reverse its direction and
stop again
after 4-6 inches.
Carry out the impact test and adjust the motor force by rotating the trimmer
(TR1)
.
If this is not sufficient, we advise you to install a rubber protective edge at the head of the gate so as to soften the impact.
If you have adjusted the sensitivity setting and added a rubber profile to the head of the gate and you are still unable to satisfy
the standards in force, you will need to add other safety devices such as a sensitive safety edge to the moving part of the gate.
When adjusting the sensors sensitivity:
TOO
sensitive - If the gate stops or reverses by itself.
NOT
sensitive enough - If the gate strikes an object
and does
NOT
stop or reverse.
TR1
adjusts for both the
OPENING
direction and
CLOSING
direction of the gate.
Both
directions
MUST
be adjusted.
Adjustment must be made so that the gate stops and reverses when meeting an obstruction.
1.
Unlock with Key and open door.
2.
Flip handle forward to released position (Unlocked).
3.
Gate can be
manually
operated. Grab the
end of the gate
to
move
it.
DO NOT
grab the gate operator to move the gate.
4.
To Lock Operator again:
Flip orange handle back to original position.
5.
Close and lock door. Operator is ready for normal operation again.
NOTE:
The gate leaf can
REMAIN UNLOCKED
and the door can be closed
and relocked by simply removing the orange handle in the released position.
NOTE:
PROG
button
will stop gate cycling
when pressed.
Released Position (Unlocked)
Door
Key
Before
performing procedure,
make sure
you disconnect
the entire automation from the electrical supply, even if it
is currently unpowered due to a power outage.
Any electric locks must be specified and released for
manual operations.
PROG
Press
ADJUST REVERSE SENSOR
POWER FAIL OPERATION
Summary of Contents for X9L
Page 2: ...2 X9 Swing Rev H...
Page 33: ...31 X9 Slide Rev H...
