Product Manual SW108 and SW104
EAE KNX Switch Actuator
PM R2.0
©
EAE Technology
www.eaetechnology.com
Page 21 / 22
§
Set with parameter
This parameter selects; ‘Limit value/Counter start’ parameter is visible. This parameter is used for
setting limit value of up counter, start value of down counter.
§
Set with object
This parameter defines whether the start/limit value can be individually adapted from the bus.
Send counter value
cyclic sending
*
after request
cyclic sending and after request
The current count of the operating hours can be learned three way ‘cyclic sending’, ‘after request’
and ‘cyclic sending and after request’.
4.4.7
Sweep Function
Sweep Parameters
Sweep function only starts to operate if the relay is switched ON. It’s an alternative way for turning
off the relay with pre-warning. The sweep function is desired to warn a person that lights will go out
shortly.
Send counter value
1…*
3
…10
The lamps connected to the relay will then be switched off as many times. Enter the number of how
many blink doing in the warning.
Blink on time
0,5sec…*
1sec
…5sec
How long the lights shall be switched on in the period.