Product Manual RCUXXYY
EAE KNX Room Control Unit
RCUXXYY PM R1.0
©
EAE Technology
www.eaetechnology.com
Page 44 / 80
4.5.2
A/B
–
Drive Blind
The blind actuator calculates the current position of a blind from the running time. This calculation
has to be performed because the drive cannot provide any feedback on its position.
Detect travel times (Up/Down)
via detection of end position
*set travel times
This parameter defines the travelling time of the blind. The time needed for a complete travel from
the upper into the lower end position.
▪
Set the parameter to “
via detection of end position
”;
The duration of the current flow that the drive uses for the movement from lower to the
upper position. The device is measured the travel time with current detection. Than up down
movements are stored.
▪
Set the parameter to “
set travel times
”;
This option is an alternative to automatic travel detection. In this way, travel times for the
lower to the upper end position are measured with a stop watch then entered into the ETS
parameters. The travel times should be measured as precisely as possible because this times
is determined during ongoing operation.
Travel time UP in s[0…6000]
Travel time DOWN in s[0…6000]
If the
“
Detect travel times (Up/Down)
”
is selected
“set travel times”
,
this
parameters are
visible. The measured travel time values are measured via stopwatch then enter this
parameter.
Disconnect output from power after
*end position, no overflow