AVIIVA® EM1
14
1043D - AVIIVA EM1 –04/11
e2v semiconductors SAS 2011
1 2 3 4 5 6 7 8 9 10 11 12
47
Ω
47
Ω
22
Ω
I/O connector
3.2.2
GPIO Connector
Camera Connector type: Hirose HR10A-10R-12SB
Cable Connector type: Hirose HR10A-10P-12P
Cable type: cable immune from interference and with twisted pairs
Signal
Pin
Signal
Pin
Line0- 1
Line3+
7
Line0+
2
Line1-
8
Line2- 3
Line1+
9
Line2+
4
GND
10
GND 5
Line4-
11
Line3-
6
Line4+
12
Camera side description
EM1 camera has a flexible I/O block :
-
Signals from Input or Output can be inverted with
LineInverter
feature
- Signals from Input can be debounced with
LineDebouncer
feature. The debounce filter allows holding
signal transitions for 0.7 µs period. During this period further transitions will be ignored.
- Input and Output can be driven by TTL, LVDS or RS422 signal type and switched just with a selection
on
LineFormat
feature.
For Input in TTLmode, connect on positive pin (Line0
+
, Line1
+
or
Line2
+)
and Ground.
For Input in LVDS, connect on the pair pins (Line0+/Line0-, Line1+/Line1-, Line2+/Line2-)
For Output in TTL mode, connect on positive pin (Line3
+
or
Line4
+)
and Ground.
For Output in LVDS mode, add three resistors as shown on the schema below at the end of the output
line:
•
Absolute maximum rating of I/O block
:
Minimum voltage
Maximum voltage
Peak current
Outputs -12V
+15V
180mA
Input -7V
+12V
?
1
2
3
4
5
6
7
8
9
10
11
12
