40
41
MAINTE NANCE
Before undertaking any maintenance, ensure that your
is disconnected from supply. If operations are to be undertaken after
using
, you must wait until the fan in the applicator has completely shut down before disconnecting the base unit from supply.
This will also ensure that the optical components are correctly cooled.
NOTE:
Unlike the fans in the applicator, which will shut down after a certain time, the fans in the base unit will continue to run until the
device is finally disconnected from supply.
❙
BASE
PLASTIC COMPONENTS
Do not clean the interior of the dedicated slot for the activation
card. All plastic components of the device must be cleaned using a
clean cloth which has been moistened in water (with no additional
products).
TOUCHSCREEN
The screen must be cleaned using a clean cloth, impregnated with
the
clean
spray (never apply the
clean
spray directly to the
touch screen).
MAINS LEAD
Check that the lead is in perfect condition (not trapped or
compressed, with no wires exposed). Clean the lead using a cloth
which has been moistened in water (with no additional products).
❙
APPLICATOR
MOBILE HEAD
Cleaning the internal optical components of the mobile head
using the
clean
spray before and after each use will ensure
the maintenance of the effective operation of your device. Never
apply the
clean
spray directly to the internal components of the
applicator.
APPLICATOR BODY
All plastic components of the applicator must be cleaned using a
clean cloth which has been moistened in water (with no additional
products).
❙
APPLICATOR CABLE
This cable must be kept clean at all times, and must be free of
any visible deterioration. Any excessive bending or compression
of the cable must be avoided. In case of any doubt regarding the
condition of this cable, it is absolutely essential that you should
discontinue the operation of your device.
❙
VENTILATION SLOTS IN THE BASE UNIT
AND APPLICATOR
The applicator and the base unit are ventilated. Grilles are
incorporated into both the applicator and the base unit, at the
bottom and on the rear at the top. You must ensure that all
grilles are clean, and free of any potential obstructions.
❙
STORAGE
• Your device should be stored in a room with a maximum
ambient temperature of 25°C, free of any excessive humidity
and not exposed to vibrations.
• If the device sustains an impact, the integrity of the optical
components should be checked.
• In case of any visible damage to the optical components: the
filter
(the flat component of red-coloured glass), the
optical guide, the tube, etc., operation of the device should be
discontinued immediately.
REMINDER:
Storage temperature : - 5°C to + 65°C.
Usage temperature : + 5°C to + 25°C.
To use and to store keeping a relative humidity under 93%.
IMPORTANT:
Ensure that no liquid enters the ventilation
grilles.