2
Using This Manual
Your E-MAG is designed to make installation as straightforwa
r
d and as simple as
possible. To further assist you, this manual includes a variety of comments and tips.
These tips are shown in
italics and in dark blue for easier identification and printing
.
Please note, the term “E-MAG” shall apply to both E-MAG and P-MAG models,
unless specifically stated otherwise.
Installation
Overview
Installing your E-MAG ignition will require you to:
1.
Install the drive gear on your ignition.
2.
Install wiring:
a. Attach three (four if you use the tack) leads to the Control Plug.
b. Spark plugs and the spark plug harness
c. MAP (manifold pressure) sensor tube
3.
Install your E-MAG ignition on the engine, set the timing, select the
maximum timing advance.
CAUTION: Do NOT strike or apply significant inward force to the ignition
shaft. Doing so could cause it to shift, and lose proper position sensor
alignment.
CAUTION: Operating the ignition without all connections – 1) power, 2) ground, 3) p-
lead, 4) plug wires with plugs (and all plugs grounded)
can result in damage to the
ignition and/or cause an electrical shock to the installer.
Please resist the
temptation to do a quick (incomplete) hook up so you can watch the ignition spark or
