E.H. Wachs 08-051-MAN, User Manual

Page: 32 / 84

Subsea Wire Saw User’s Manual
28 Part No. 08-051-MAN, Rev. 1-0709 E.H. Wachs
Figure 3-7. The photo shows the size stamps on the
WS-5230 model. The pin is in the 46-52” position.
Positioning the Clamp Arms
Do not attempt to change the
clamp arm positions while the
saw is in a vertical position.
The clamp arms may fall
when the pins are removed,
resulting in personal injury
and equipment damage.
Make sure the saw is sitting horizontally on a level surface
before you adjust the clamp arms.
1.
Remove the spring clips from both pin ends of the
forked pin, then pull the forked pin out of the frame.
Figure 3-8. Remove the spring clips from both ends of
the forked pin, then pull the pin out from the other
side.
2.
Slide the clamp arm assembly so that the mounting
holes line up with the appropriate hole pair for the
pipe size you are cutting.
WARNING