Soldering EC3 Lead to Your Battery
We have included our E-flite
™
EC3 battery connector for
your convenience. This will allow your battery to connect
to the EC3 lead on the included speed control.
1. Carefully solder your positive red battery lead to
the gold connector while keeping the black lead
covered to avoid shorting.
2. Push the positive wire with gold connector into
the positive side of the blue housing until is snaps
in place. This process may take some moderate
and careful force.
3. Repeat these steps for the negative side.
4. With the aircraft fully assembled, install the
battery into the battery compartment. Secure the
battery using the hook and loop tape and a hook
and loop strap.
Note
: Place a piece of hook and loop tape on
the bottom of the battery and on the fuselage
where the battery rests. This will keep the
battery from shifting forward or backward
during extreme maneuvers.
19
Summary of Contents for Mini Ultra Stick PNP
Page 1: ...Mini Ultra Stick PNP Assembly Manual...
Page 25: ...25...
