Tail Installation
Required Parts
• Fuselage
• Rudder/Fin
• Stabilizer/Elevator
• 3mm locknut (2)
• 3mm washer (2)
1. Slide the rudder into position on the fuselage.
The threaded rods extend through the bottom of
the fuselage.
2. Attach the stabilizer using two 3mm washers and
two 3mm locknuts. Do not tighten the locknuts all
the way until after the wing is installed and you
check the alignment.
Note
: The tail section is removable for easy
transporting if needed. When re-attaching,
always check your alignment before flight
to make sure the tail is square with the wing
before tightening the locknuts completely. See
instructions on page 22.
13
Summary of Contents for Mini Ultra Stick PNP
Page 1: ...Mini Ultra Stick PNP Assembly Manual...
Page 25: ...25...
