1
E-flite Mini Pulse PNP Assembly Manual
3. Slide the #4 washers onto the threaded rods. Thread
the nuts onto the rod, tightening them snugly against the
bottom of the fuselage.
Note
: The tail section is removable for easy transporting
if needed.
4. Locate the 4 in (102mm) linkage wire. Slide the
“Z” bend into the center hole of the elevator control
horn. Pass the linkage through the pushrod connector
on the servo arm. Turn on the radio and plug the
elevator servo into the receiver. Center the elevator
trim and stick, and check that the sub-trim (if a
programmable radio) has been set to 0. Install the
servo horn back onto the elevator servo. Use a 2mm x
4mm screw to secure the linkage.
5. Repeat Step 4 for the rudder linkage.