1
E-flite Jenny JN-4 Slow Flyer ARF Assembly Manual
Wing Installation
Required Parts
• Wing (top and bottom)
• Outer strut (2)
• Inner strut (front) (2)
• Inner strut (rear) (2)
• 2mm x 4mm sheet metal screw (8)
Required Tools and Adhesives
• Phillips screwdriver
• Foam-safe CA
• Hobby knife
• Felt-tipped pen
1. Position the bottom wing on the fuselage. Line the
holes in the wing up with the holes in the cross supports
in the fuselage. Use four 2mm x 4mm sheet metal screws
to attach the bottom wing to the fuselage. Do not over-
tighten the screws and damage the wing.
2. Slide the outer struts through the bottom wing. Note
the direction of the strut. The rear has an angle, while the
front is straight.
3. Use a hobby knife to make two small holes in the
mounting points of the cabane struts. Make the hole in
the rear mounting pads at this time.
