EN
Post Flight Checklist
1
Disconnect the fl ight battery from the ESC (Required for Safety
and battery life).
2
Power OFF the transmitter.
3
Remove the fl ight battery from the aircraft.
4
Recharge the fl ight battery.
5
Repair or replace all damaged parts.
6
Store the fl ight battery apart from the aircraft and monitor the
battery charge.
7
Make note of the fl ight conditions and fl ight plan results, planning for
future fl ights.
Problem
Possible Cause
Solution
Oscillation
Damaged propeller or
spinner
Replace propeller or spinner
Imbalanced propeller
Balance the propeller. For more information, view our propeller balancing video on Horizon Hobby’s You-
tube channel https://www.youtube.com/watch?v=OXuNnYQO2s4
Flight condition variations
Adjust gain to current fl ight conditions (wind, updrafts, local conditions [elevation, humidity,
temperature, etc.])
Motor vibration
Replace parts or correctly align all parts and tighten fasteners as needed
Loose receiver
Align and secure receiver in fuselage
Loose aircraft controls
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Worn parts
Adjust gain to compensate for parts wear or replace worn parts (especially propeller, pivot points or
servo)
Irregular servo rotation
Replace servo
If oscillation persists...
Decrease gain (refer to receiver manual)
Inconsistent fl ight
performance
During in fl ight trimming,
the user did not wait the
required 3 seconds for new
trim settings to be learned
by the AS3X system
After adjusting trim in fl ight do not touch the control sticks for 3 seconds. Allow for the new trim settings
to be learned by the AS3X system
Incorrect response
to the AS3X Control
Direction Test
Incorrect direction settings
in the receiver, which can
cause a crash
DO NOT fl y. Correct the direction settings (refer to the receiver manual), then fl y
Troubleshooting Guide AS3X
17