EN
Horizontal Stabilizer Installation
Continued
4. Remove the screw securing the servo arm and remove the servo arm.
5. Attach the Z-bend end (
D
) of the control linkage to the servo arm’s outer
most hole with the Z-bend facing out as shown.
6. Reinstall the elevator servo arm onto the servo. Ensure that it is oriented
correctly on the servo output spline.
7. Ensure the elevator servo arm is in the correct position and the elevator
is centered, then snap the ball link (
E
) onto the ball of the elevator control
horn (
F
). Ensure that the elevator is centered, remove and adjust the ball
link if necessary.
When needed, disassemble in reverse order.
Wing Installation
Bottom Wing Placement
1. Remove the canopy hatch (
A
) from the fuselage by pulling up on the
back side of the hatch. Avoid pulling directly on the canopy.
2. Slide the shorter of the two wing tubes (
B
) into the hole of the fuselage.
3. Guide each aileron servo wire through each side hole and inside of the
fuselage.
4. Slide each wing over the wing tube then push the wing halves all the
way into place while pulling the servo wires to be sure they are not
trapped between the wing and fuselage. Ensure the wings are fully
inserted into the fuselage.
Continued
Model Assembly
Continued
D
E
F
A
B
7