1
1
2
3
EN
A
B
R-AIL
L-AIL
R-AIL
L-AIL
Quickstart Guide
Charge the Flight Battery
Assemble the Aircraft
Install (4) AA Transmitter
Batteries (RTF Aircraft)
CAUTION:
See the aircraft
instruction manual for a
complete list of charging instructions
and warnings. All instructions and
warnings must be followed exactly.
Mishandling of LiPo batteries can
result in a fi re, personal injury and/or
property damage.
Refer to the aircraft instruction manual for complete step-by-step instructions.
Landing Gear
Wing
Tail
USB power source,
not included
Both the charge lead
(A)
and the balance
lead
(B)
must be connected for the
charge cycle to begin.
LED Indications
Flashing purple: Charging
Solid green: Charging complete
Solid red: Charging error
Loosen the nose
gear bracket screw.
Insert the nose gear
in the collar and
tighten the
screw against
the fl at-spot
on the gear
wire.
Attach vertical fi n and
horizontal stabilizer into place
with 2 screws.
Attach clevises to vertical and
horizontal stabilizer control horns.
Peel the
pre-installed
two-sided tape
and adhere wing
covers to the front
and back of the wing.
Slide the
two wing
halves
together
over the
carbon
wing tube.
Connect the left and right
aileron servo connectors to the
aileron servo wire
extensions from
the fl ight controller.
Going from front to back
over the wing, attach 8
rubber bands to secure the
wing to the fuselage.
Connect clevises to
the control horns.
Remove the pin from nose gear bracket.
Slide the main
gear in the
slot until it
locks.
Install the stabilizer rod, then apply the
included two-sided tape to the
area where wings will meet.
