CONVENTIONAL FEATURES
31
Programming a Scan List
When full keypad (15-key) models, each of the three scan lists is
user programmable if the Scan Edit option switch is programmed and
user programming of the list is allowed. Scan list programming is not
available with limited keypad (3-key) models. Proceed as follows to
program a scan list:
1. Make sure all scanning is off (neither the standard scan “
S
” icon or
radio-wide scan
icon displayed).
2. Press the Scan Edit option switch and then within 2 seconds press the
number key (1-3) corresponding to the scan list you want to edit. If a
list is not selected within the allotted time, the last active conventional
standard scan list is automatically selected. The selected list is indicated
as “SCAN x”. If user programming is disabled on a list, “NO LIST” is
momentarily displayed and it cannot be edited.
3. Select the channel you want to add or delete using the
and
keys. To change zones, press the F1 key and select the new zone.
4. If the selected channel is in the scan list, the box
around “
S
” is
indicated in the upper left corner of the display. To add the channel to
the scan list, press the “1” key, and to delete the channel, press the “2”
key.
NOTE: The priority channel cannot be deleted (see “Priority Channel
Sampling” description which follows).
5. To exit this mode and save the changes, press the ENT or CLR key.
Transmitting in Scan Mode
When the transmitter is keyed with scanning enabled, the radio can
be programmed so that the transmission always occurs on one of the
following channels:
