9
S1
D1
I
U
D2
S2
1.
Current / voltage output:
If the device is switched from current to voltage output using the
configuration software the two jumpers must be located as follows:
for current signals:
for voltage signals:
2.
RS232:
Serial interface for configuration of the EE36.
3.
Display:
pin connector for optional display.
4.
Push-Buttons for calibration purposes: see Hardware, chapter 7 “Humidity/Temperature calibration”
5.
Diagnosis LEDs:
see Harware, chapter 7 "Humidity/Temperature calibration,"
and Hardware, chapter 8.3 "Self diagnosis and error messages"
5.1
Circuit board
After removal of the housing cover, the following operating components on the circuit
board may be accessed for adaptation of the transmitter to the desired configuration.
5.
OPERATING COMPONENTS
I
U
I
U
Hardware
OUT2
OUT1
OUT2
OUT1
1. Current / voltage output
2. RS232
3. Display
4. Push-button
5. Diagnosis LEDs
4.5
Connection configuration of bottom part of the housing
with integrated power supply / 100...240V AC (option V01)
1
2
3
4
5
Euro-Standard
plug for RS232 and
analogue output
(front view)
plug for 100-240V
metal housing
(front view)
plug for 100-240V
polycarbonate housing
(front view)
Description:
Connection assignment:
RxD / B-
5
TxD / A+
4
GND 3
OUT1 2
OUT2 1
Description:
Connection assignment:
grounding PE
phase (L1)
1
neutral wire (N)
3
Description:
Connection assignment:
phase (L1)
1
neutral wire (N)
3
External diameter of supply cable: 10-12mm
(0.39-0.47”)
Maximum wire cross section: 1,5mm² (AWG 16)
The protection of the supply cable against excess current and
short-circuit shall be in accordance with national and local codes.
Bottom and centrepiece of the housing shall be grounded!
Summary of Contents for EE36 Series
Page 31: ...31...
