E+E Elektronik EE36 Series, Manual

Page: 10 / 32

10
- MIN; MAX: see point "MIN/MAX Function"
- CALIB LOW; CALIB HIGH: indicates the low or high humidity/temperature calibration point.
- REL1 / REL2: Status Relay
- "ERROR 01....04": see Hardware, chapter
8.3 “Self-diagnosis and error messages
”
6. STATUS LINE:
6. Status line
3. Measurand selection and
4. Min/Max function
1. Measurand
5. Measured values
2. Units
aw: 0.38
REL1
SI SI US
T Temperature °C °F
aw Water activity
x Water content ppm ppm
1. MEASURAND
:
2. UNITS
:
3. MEASURAND SELECTION:
5.2
Display module / Option
Press the
∆
or
∇
button to
select the desired
measurand
4. MIN / MAX FUNCTION:
Transmitters of the EE36 series can display the highest and lowest measured value measured
since the last reset.
Highest measured value:
1. Select the desired measurand.
2. To display the maximum value of the selected measurand, press the
∆
button for at
least five seconds.
3.1.To reset the instrument to its normal operating status, press the
∆
button once again
for five seconds.
3.2.If both buttons are pressed for at least five seconds while the maximum value is
displayed
→
the "MAX" symbol disappears
→
the maximum value will be deleted
(Reset).
Lowest measured value:
1. Select the desired measurand.
2. To display the minimum value of the selected quantity, press the
∇
button for at least
five seconds.
3.1.To reset the instrument to its normal operating status, press the
∇
button once again
for five seconds.
3.2.If both buttons are pressed for at least five seconds while the minimum value is
displayed
→
the "MIN" symbol disappears
→
the minimum value will be deleted (Reset).
Hardware
5. MEASURED VALUES:
from up to unit
Water activity aw 0 1
Temperature T -40
(-40°F)
180
(356°F)
°C
(°F)
Water content x 0 1000 ppm
The dominant value of the appropriate quantity is displayed in this field. For the factory
configuration, the measured values may fall between the measurement ranges shown below.
The measurement ranges indicated above can be set to individual requirements using the
configuration software (see software manual; chapter 5 "Index - Index Cards").