dyras WMHD-1600, Instruction Manual

Page: 5 / 27

EN
WMHD-1600 WMHD-1600
8
9
excessive use,
– premature amortization, blow out of the filament,
– Increase noise emission,
– material fatigue, the local overheating of electric and frictional mechanical
elements.
Storing the appliance in cold or frosty environment may cause:
– damage to the plastic and rubber components; if they become fragile, this
may result in a safety risk.
– oxidation resulting from condensation, and corrosion of the metal
components.
Direct and indirect heat (e.g. being too close to an oven or a heating appliance) can
cause:
– damage, deformation, softening or melting of plastic or rubber parts and
casing elements, or deterioration of electrical insulation.
Following the operating instructions and avoiding any of the conditions listed
above will help you increase the lifespan of the appliance. The manufacturer is
not responsible if the appliance is stored inappropriately or contrary to these
instructions. You are recommended to have the appliance serviced regularly by an
authorised engineer to keep it working for as long as possible.
Please respect the environment when the appliance reaches the end of its life.
Electrical products must not be disposed of with other residential waste because they
can damage the natural world and may be hazardous to human health. You should
dispose of the appliance at an appropriate recycling site or by using a collection
service that specialises in electrical appliances.
You may wish to contact the retailer or the manufacturer if you are unable to find
convenient local recycling facilities as they have some legal responsibilities for
recycling electrical products.
Please keep this instruction manual. If you give the appliance to anyone else, you must
give them this instruction manual, too!
MAIN PARTS AND CONTROLS
1. Hair dryer
2. Mains switch (high-off-low)
3. Curly power cable between the dryer and the holder
4. Mains power cable and plug (not visible on the figure)
5. Wall-mounted holder
6. Metal bracket
7. Hardware for mounting (3x wall plugs, 4x screws) (not visible on the figure)
POWER SUPPLY
The hair dryer must only be connected to mains voltage between 220-240VAC,
50/60Hz. Make sure your electricity supply is within these limits before connecting
the appliance.
BEFORE USING THE HAIR DRYER
Unpack the appliance and remove all the packing materials.
Inspect the appliance and the accessories carefully to verify their soundness and undamaged
condition. Only perfectly sound and damage-free appliances may be connected to the electrical
mains.
Fixing the hair dryer to the wall
This procedure requires three holes to be drilled in the wall. We recommend that you arrange for
this to be carried out by a professional contractor.
1. Remove the metal bracket by pulling it downwards from the wall-mounted holder.
2. Hold the metal bracket against the wall and mark where the holes need to be drilled. Take
care to ensure you are mounting the appliance in a safe place.
3. Drill three holes to accommodate the full length of the wall plugs. Make sure you use an
appropriate drill bit for the wall material and the diameter of wall plug.