Dynojet sd12, Installation Manual

Page: 27 / 50

2-9
I N S T A L L A T I O N
Cable Routing
Version 2 Model SD12 Scooter Dynamometer Installation Guide
R
OUTING THE
C
ABLES
Use the following instructions along with Figure 2-6 on page 2-10 for routing and
connecting the cables.
1 Attach the CAN pendant cable (E) to the front of the DynoWare RT module.
2 Attach the speed pickup/brake cable (G) to DRUM 1 on the back of the

DynoWare RT module.
Note: The white two-pin connector on the speed pickup/brake cable is not used.
3 Attach the CAN adapter cable (J) to the back of the DynoWare RT main module.
4 Attach the CAN dyno user cable (I) to the CAN adapter cable (J) and route to the
AFR assembly. Attach the CAN dyno user cable (I) to the AFR assembly.
Note: The DynoWare RT AFR is an optional accessory. Refer to the Air Fuel Ratio
Module Installation and User Guide (P/N 98200062) for more information.
5 Insert the CAN termination plug (L) in the CAN dyno user cable (I).
6 Insert the O2 sensor(s) into the sensor block on the AFR assembly, plug sensor
connectors into AFR, and tie the sensor cables.
7 Connect the power cable (B) to the AFR module. Plug the power cable into your
power source.
8 Attach the network cable (C) to the back of the DynoWare RT module.
9 Attach the network cable (C) to your network. Refer to “Network Connections” on
page 1-10 for more information.
10 Attach the primary/secondary pickup cable (F) to the DynoWare RT module.
11 Attach the power cable (A) to the DynoWare RT module. Plug the power cable into
your power source.
12 Attach the remote atmos cable (D) to the DynoWare RT module and stick the
atmos module to the side of the dyno.
13 Remove the PCV CAN termination plug (K) from the front of the DynoWare RT
module and save for use with the PCV module.
13a Attach the PCV or OBD2 module using the CAN powersports cable (H).
13b Insert the PCV CAN termination plug (K) in the PCV module.
Note: If you are not using a PCV, be sure to save the PCV CAN termination

plug (K) for future use.
J - 76950807 CAN control cable, adapter, 2' connects the DynoWare RT to the CAN control and
CAN dyno user cables
K - 76423025 PCV CAN termination plug connects to the PCV module when connected to the
DynoWare RT using the CAN Powersports cable
L - 76423045 CAN termination plug connects to the last CAN cable in the CAN network
cable chain
cable brief routing description
C