2-35
I N S T A L L A T I O N
Cable Routing
Version 2
Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
R
OUTING
THE
C
ABLES
Use the following instructions along with Figure 2-29 on page 2-37 for routing and
connecting the cables.
You will need the following part:
• 43991080
Split Snap Bushing (2)
1
Remove the two screws securing the cable pass through cover closest to the
monitor support and set it aside.
2
Route the CAN pendant cable (C) through the cable pass through closest to the
monitor support and attach to B on the front of the DynoWare RT module.
3
Route the network cable (A) through the cable pass through closest to the monitor
support and attach to the back of the DynoWare RT module.
4
Route the 15-pin control panel cable (T) from the POD intercept board, through
the cable pass through closest to the monitor support, and attach to the control
panel. Refer to “Control Panel and Cable” on page 2-50.
5
Place a split snap bushing around the pendant cable and secure the cable through
one hole in the cable pass through cover.
6
Place a split snap bushing around the control panel cable and network cable and
secure both cables in the other hole on the cable pass through cover. The bushing
should be around the cable protective wrap.
7
Secure the cable pass through cover to the dyno using the two screws removed
earlier.
8
Attach the speed pickup/brake cable (J) to DRUM 1 on the back of the DynoWare
RT module.
Note:
The white two-pin connector on the speed pickup/brake cable is only used
if an air brake is installed.
9
Attach the temp sensor cable (L) to the eddy current brake driver.
10 Attach the load cell cable (M), if present, to the eddy current brake driver.
11 Route the e-stop cable (K) from P7 on the front panel of the CPI to the back of the
DynoWare RT main module.
12 Route the AFR power cable (N) from the DIN rail to the AFR assembly.
13 Insert the O2 sensor(s) into the sensor block on the AFR assembly, plug the sensor
connectors into the AFR, and zip tie the sensor cables away from moving parts.
14 Attach the network cable (A) to your network. Refer to “Network Connections” on
15 Route the power cable (I) from the DIN rail to the back of the DynoWare RT
module.
16 Attach remote atmos cable (B) to the DynoWare RT module and stick the atmos
module to the side of the dyno.
17 Attach the RPM pickup cable (E) to the front of the DynoWare RT module.
