5-3
B A S I C D Y N O O P E R A T I O N
Loading the Vehicle
Version 2
Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
5
When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, place it in park.
• If the vehicle has a manual transmission, place it in gear.
6
Attach two tie-down straps from the ground hooks to the rear of the vehicle.
7
Attach two tie-down straps from the ground hooks to the front of the vehicle.
Note:
If you are running an all wheel drive ATV, use differential jacks to get the
front wheels off the dyno.
Note:
When running an ATV, you may need to increase the tire pressure so the
tire does not come in contact with the decking.
8
Tighten the four tie-down straps evenly making sure the drive wheels remain
centered on the drum.
Never perform a dyno run if the tie-down straps are not in place or they
are damaged.
Figure 5-2: Load the Vehicle—Top View
