PowerDepot H5B series User Manual
15
Inverter connection
Note:
If there is any question during installation, please contact retailer to avoid damage to the
equipment.
①
When the system is used independently:
Note: Before installation, please confirm whether the DIP switch mode of PowerDepot
H5B is correct according to the the inverter model. For specific DIP operation methods,
please refer to
“
3.2.4 Battery module DIP switch instruction and description.
”
Except
for the inverter specified by the customer's special requirements, the factory default
DIP switch mode is DIP Switch mode 1 (ADD: 0010).
If the inverter is equipped with other DIP switch mode, open the cover and set DIP
switch mode to the correct mode. Before opening the front panel to operate, you must
inform us the ID of the PowerDepot H5B. We will record the battery ID and give device
opening operation authorization. Except changing the DIP switch mode, no other
operations can be done .
The connection between inverter and battery should apply the power cable and
communication cable which has been offered in your accessory package. ( the
communication cable is standardized type and The applicable inverter module has been
indicated on the cable Label. Please contact us if the communication cable can not
match yours inverter )
The cable connection procedure showed below:
Keep the battery system at power off state, connect the power cable to the interface on
the input side of the inverter first, and then connect the power cable to the interface
on the battery side.
The battery output interface is a quick connector, and the power cable (positive,
negative) plug can be directly inserted into the battery socket. The power cable cross
section is 25 mm
2
.
Communication interface connection
