Dynatronix Diamond 10kW Series, Operating Manual, Page: 87 / 150

Diamond 10kW Manual Dynatronix, Inc.
198-1603-03 Rev 01 Page 87 of 150
A.6.1 Cycle Setup Menu
         
   
. . .
.
. .

.
Cycle Setup
Menu
Enter the cycle setup menu from the unit
setup menu.
    

    

    

    

          
 
Cycle preset in whole
units.
Cycle preset in tenths of units.

Cycle preset in hundredths of
units.

Cycle preset in thousandths of
units.
 
Return to Unit Setup
Menu
Discard any changes made
during this edit session
(only shown if changes
were made).
Save any changes made
during this edit session
(only shown if changes
were made).

      


 
Cycle Time Control =
Manual Time Control
Cycle Time Control =
Real Time Control

Cycle Time Control =
Amp Time Control
 


 
Unit = ATC Amp Minutes
If RTC cycle control were
selected then “RTC” would be
displayed rather than “ATC”
Unit = ATC Amp Hours
If RTC cycle control were
selected then “RTC” would be
displayed rather than “ATC”
             
  

 
When the cycle preset is displayed the top display indicates the units and which half of the preset is displayed. The preset
setting is displayed four digits at a time. When the last screen blinks ‘Lo’ the lower four digits are displayed. When the
last screen blinds ‘Hi’ the upper four digits are displayed. Turn the voltage encoder to change between ‘Hi’ and ‘Lo’. Use
the current encoder to modify the preset value.
   