c) press out the lock spring local on the left feeding bearing by small “-” shape screwdriver, then
unload the plastics roller.\
d) Press out the block
which
is on the bearing
by small“+” screw driver, if necessary, it can be
tapped out.
e) Press out lock spring which is in left side feeding bearing by small “-” screwdriver, then take off
the screw on the sides of the bearing .
f)
Push out the bearing , take out the hopper.
g)
Replace the hopper, and fix up bearing ,fasten the screw, and recover all the parts as them are.
h)
Fix up the main motor cincture, main board, and then fix all the sensor on the main board, make
sure all have been connected correctly ,then power on and adjust the hopper.
I)
Fix up the sides covers then over.
Summary of Contents for DCI020-M
Page 1: ......
Page 7: ...3 3 plug board and electronic program 4 Sensor position ...
Page 21: ......
