Dynapac DTR75, Operating Instruction

Page: 102 / 120

5. Pull the water lines off the front and rear spray tube and pull
the spray tubes out of the frame.
6. Flush the water tank out with a strong water jet.
7. Drain off all water and dirt.
8. Close the cover of the drain bore again.
9. Fill the water tank with clean water to flush contaminants out
of the lines.
Do not fill the water tank completely. Only
use as much water as necessary to clean the
lines.
10. Switch the water spraying system on to flush contaminants
out of the lines.
11. Flush both spray tubes well when cleaning.
12. Insert the spray tubes, slide on the water lines and insert the
split pins.
13. Fill the water tank with clean water and close the cap.
8.11.2 Adjusting the scrapers
Protective equipment: n Working clothes
n
Safety shoes
n Protective gloves
1. Check the condition of the front and rear scrapers, as well as
both middle scrapers regarding settings and condition; read-
just them if necessary.
B-834-0268
Fig. 106
B-834-0269
Fig. 107
Maintenance – As required
DTR75 102