Dynapac DRP45DX, Operating Instructions Manual

Page: 60 / 124

4. Turn the ignition key to position “I”.
ð
The oil pressure control light (red) lights up.
5. If the engine control light (yellow) also flashes, evaluate the
flashing interval and perform troubleshooting
Ä
Chapter 9.5
‘Engine control light’ on page 114 .
6.
The starter switch is designed with a re-start
lock. The ignition key must first be turned
back to position “0” before a new starting
attempt can be made.
NOTICE!
Components may get damaged!
– Starting attempts should not exceed 30
seconds uninterrupted or max. 3 times
for 10 seconds. Then allow the starter to
cool down to ambient temperature.
– If the engine has not started after these
attempts, determine the cause.
Turn the ignition key to position “II”.
ð
The starter cranks the engine.
The oil pressure control light goes out.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while
before starting work. Do not operate
the engine immediately under full
load.
B-ELE-0081
Fig. 48
B-695-0102
Fig. 49
B-ELE-0082
Fig. 50
Operation – Starting the engine
DRP45DX 60