Dynapac DRP20, Operating Instructions Manual

Page: 53 / 112

7. Pull the rope by the starter handle, until resistance can be
felt.
8. Guide the starter handle back to initial position.
9.
CAUTION!
Danger of injury caused by uncontrolled
machine movement!
– Always hold on to a running machine.
– Always keep an eye on a running
machine.
NOTICE!
The starter rope may tear off!
– Do not pull the starter rope all the way
against the end stop.
Pull the starter handle quickly and with power.
10. Manually guide the starter handle back to initial position.
11. If the engine does not start during the first attempt, repeat the
starting process.
12. Open the choke bit by bit when the engine is running.
13. Run the engine warm for approx. 1 to 2 minutes in idle
speed.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while before
starting work. Do not operate the engine
immediately under full load.
14. If the engine stops again after approx. 3 to 5 seconds:
n Close the choke again.
n
Repeat the starting procedure.
Fig. 29
Fig. 30
Fig. 31
Operation – Starting the engine
DRP20 53