Dynapac DR6X, Operating Instruction

Page: 97 / 114

Protective equipment: n Working clothes
n Protective gloves
Special tool: n 16 mm spark plug spanner
1. Park the machine in secured condition
Ä
Chapter 6.4
„Parking the machine in secured condition“ on page 55 .
2. Allow the engine to cool down for at least 15 minutes.
3. Pull off the spark plug connector (1).
4. Clean the area around the spark plug.
5. Unscrew the spark plug with a 16 mm spark plug spanner
(2).
6. Check the condition of the spark plug, clean if necessary.
7. In case of excessive combustion residues or burned off elec-
trodes, replace the spark plug
Ä
Chapter 8.9.2 „Replacing
the spark plug“ on page 81 .
8. Check the electrode gap of the spark plug with a feeler
gauge, if necessary, adjust the gap.
ð
Nominal value: 0.6 - 0.7 mm (0.024 - 0.028 in)
9. Carefully screw in the spark plug by hand.
10. Once the sealing surface of the used spark plug is in contact,
tighten for another 1/8 to 1/4 turn with the spark plug
spanner.
Fig. 116
Fig. 117
Maintenance – As required
DR6X 97