Dynapac DR6X, Operating Instruction

Page: 51 / 114

6.
CAUTION!
Danger of injury caused by uncontrolled
machine movement!
– Keep your feet clear of the tamper foot
plate.
– Always hold on to a running machine.
– Always keep an eye on a running
machine.
NOTICE!
The starter rope may tear off!
– Do not pull the starter rope all the way
against the end stop.
Pull the starter handle quickly and with power.
7. Manually guide the starter handle back to initial position.
8. If the engine does not start during the first attempt, repeat the
starting process.
9. Open the choke 3 to 6 seconds after the engine has started
running.
10. Set the throttle lever to position "MIN" and let the engine run
at idle speed to warm up for 1 to 2 minutes.
NOTICE!
Danger of engine damage!
– Warm up engine for a short while before
starting work. Do not operate the engine
immediately under full load.
11. Should the engine stop again after approx. 3 to 5 seconds:
n Close the choke again.
n Repeat the starting procedure.
Fig. 27
Fig. 28
Fig. 29
Operation – Starting the engine
DR6X 51